Was this page helpful?
decommission - Deactivate a selected node by streaming its data to the next node in the ring.
For example:
nodetool decommission
Use the nodetool netstats command to monitor the progress of the token reallocation.
Note
You cannot decomission a node if any existing node is down.
See Remove a Node from a ScyllaDB Cluster (Down Scale) for procedure details.
Before you run nodetool decommission:
Review current disk space utilization on existing nodes and make sure the amount of data streamed from the node being removed can fit into the disk space available on the remaining nodes. If there is not enough disk space on the remaining nodes, the removal of a node will fail. Add more storage to remaining nodes before starting the removal procedure.
Make sure that the number of nodes remaining in the DC after you decommission a node
will be the same or higher than the Replication Factor configured for the keyspace
in this DC. If the number of remaining nodes is lower than the RF, the decommission
request may fail.
In such a case, ALTER the keyspace to reduce the RF before running nodetool decommission.
Was this page helpful?